About the fishing rod bending problem:
1, now the fishing rod on the production technology, glass fiber and carbon fiber material, each part of the possibility of a curved line, it is impossible to eliminate one hundred percent.
2, especially the carbon rod, ontology, itself is a fiber with better toughness, hang rod itself will not, though how much compared to the glass rod will be a little bent, but the function of strength and usability are no problem. A guide ring of yugan method of use:
S telescopic pole
1, first of all to remove protection guide ring protecting cap, from the bottom guide ring towards the top of the ring, in turn, through the wires.
2, yugan stretching order should begin from the tip section begin to pull out, every two chimeric slightly forced tighten, so that it is fixed.
3, yugan, after all pull out all the guide ring should be in a straight line. Fora after use, should first start from section B loose Mosaic, and so one by one day to recover.
S thrust rod
1, will tip section, and the second quarter, third quarter and B segment, in turn, plug, plug when slightly twisted hard chimeric, make up the fixed.
2, in the booth on the line wheel, pull out the line, from the biggest, in turn, through the guide ring towards the top of the ring.
3, after use, when you receive pole from section B in turn loose tongue, and then in turn in one day.
4, to take over the joint. To prevent the loose, with 4 to 5 mm gap when producing, please do not insert forcibly.
Without a guide ring yugan matters needing attention when using:
1, before taking to towards the plug and pull rod body in a straight line, can be damaged if wrest, gouging out rod mouth; Overexert section bending rod or used in the line into chaos ball, is likely to cause the fishing rod breaking.